Cleaning The Burner - Dometic RM2351 Operating Instructions Manual

CLEANING THE BURNER
Electrode
rYq\
l'@pl
ft
Burner Tube
8.
7.
Be sure to
check the burner flame for proper ap-
pearance.
The flame should be clear
blue over
the slots of
the
burner.
Clear
Blue Color
Of Flame
Check
the electrode for proper location and gap.
Adjustments may be
made with needle nose
pli-
ers if necessary.
1/8"
to 3/16"
(3-5 mm)
9.
Turn on
the
manual gas shut off valve.
10.
Examine all
fittings
for
leaks. Use a commercial
non-corrosive bubble solution.
11.
Connect
the
120
VAC power
cord.
12.
ReconnecUTurn on
the 12VDC
power.
13. Check LP
gas safety shutoff.
1.
Turn off
the
refrigerator
2.
Unplug
the power cord from the
120
VAC
out-
let. Disconnect the
wires
or shut off
the
12
VDC
power supply to the refrigerator.
Turn
off
the manual shut off
valve.
Remove cover
from burner housing.
Clean the burner tube with a
brush. Blow
out
the
burner
with compressed
air.
FIRE HAZARD. Never use
a
wire or pin to clear
obstructions from the burner iet as damage
will occur.
Do not attempt to adjust the
burner
jet.
Failure to obey
this warning could
cause
a
fire resulting in death or serious injury.
6.
Verify
that the
burner
jet slots are centered
un-
der the flue tube.
3.
4.
5.
f.\
Refrioerator removal and installation should
be
K/
perfoimed
by
a
qualified service technician.
Before removing
the refrigerator:
rrF
1.
Verify that
the
120
VAC power cord
is
discon-
r}rg
nected
at
the rear of
the
refrigerator.
2.
Verify that
the 12VDC leads are disconnected
and capped at
the
rear of
the refrigerator.
3. Shut off the gas
supply.
4.
Disconnect and cap
the LP gas line at rear
of
refrigerator.
Always use a backup wrench when loosing
and
tightening LP
gas connections.
To
remove
the refrigerator:
lTF'1.
Remove the screws anchoring
the refrigerator
r -.,'
to the enclosure.
To replace
the refrigerator:
ftF
1.
Make sure
the
sealing strips (isolating the ap-
IP\E'
pliance combustion system from the vehicle
interior)
are
properly positioned
for
a
complete
seal.
Slide
the
refrigerator back into the compart-
ment.
Replace the screws anchoring
the refrigerator
to the enclosure.
Reconnect
the
LP
gas supply line
at
the
rear
of
the
refrigerator.
Always use a backup wrench when loosing
and
tightening
LP gas connections.
5.
Check all connections
for LP gas leaks.
6.
Reconnect
the
12
VDC leads at rear
of
refrig-
erator.
7.
Reconnect
the
120
VAC power cord at rear
of
refrigerator.
2.
3.
4.
2.
Slide
the
refrigerator out of the compartment.
14