Thermostat Troubleshooting - Hearth and Home Technologies PS35 Service Manual

ECO CHOICE PELLET STOVE SERVICE MANUAL
THERMOSTAT CIRCUIT TROUBLE-SHOOTING
1) UNPLUG THE STOVE & REMOVE THE CONTROL BOX
2) TURN ON THE THERMOSTAT & MAKE SURE THE ACCESSORY JUMPER IS IN PLACE
3) CHECK FOR CONTINUITY AT PIN 7 & PIN 9 ON THE JUNCTION BOX
IF THE CIRCUIT HAS CONTINUITY: REPLACE THE CONTROL BOX
IF NO CONTINUITY, CONTINUE TO THE NEXT STEP
4) INSTALL A JUMPER WIRE ON THE THERMOSTAT & CHECK FOR CONTINUITY AT PIN 7 & PIN 9
IF THE CIRCUIT HAS CONTINUITY: REPLACE THE THERMOSTAT
IF NO CONTINUITY, CONTINUE TO THE NEXT STEP
5) REMOVE THE THERMOSTAT WIRES FROM THE THERMOSTAT BLOCK & INSTALL A JUMPER WIRE
IF THE CIRCUIT HAS CONTINUITY: REPLACE THE THERMOSTAT WIRE
IF NO CONTINIUTY, CONTINUE TO THE NEXT STEP
6) INSTALL A JUMPER WIRE ON THE T-STAT BLOCK & THE RESET BUTTON. CHECK CONTINUITY (7&9)
IF THE CIRCUIT HAS CONTINUITY: REPLACE THE RESET BUTTON
IF NO CONTINUITY: REPLACE THE JUNCTION BOX/WIRE HARNESS
PAGE 16