Table of Contents
Advertisement
48
MENU SETTINGS
EN
Changing the Menu Settings
You can change the menu settings to customize
your camera. Access the desired menu screen
by following the steps below, then change the
various settings.
Power Switch
Lock Button
MODE
MENU
1
Select the operation mode.
For Recording Menus:
Set the power switch to
For Playback Menus:
Set the power switch to
2
Select
(video) or
MODE switch.
3
Press MENU. The menu screen appears.
4
Select the desired sub menu and menu item
with
/
and 49.
To return to the normal screen, press MENU.
To display the operation guide, press INFO/
when the menu screen is displayed. (The
operation guide is not displayed depending on the
type of the menu.) To remove the operation guide,
press INFO/
again.
Even if the menu item is displayed, some item
cannot be set depending on the selected mode
(video/still image, recording/playback). In this
case, sub menu cannot be accessed or setting
cannot be changed.
INFO/
49
.
.
(still image) using the
Common Menus for All Modes
[ ] = Factory-preset
BASIC SETTING
PRESET
EXECUTE: Resets all settings to the factory-
preset.
[CANCEL]: Returns to the menu screen without
executing reset.
DEMO MODE
OFF: Disables the function.
[ON]: Activates demonstration mode and shows
various features on the display.
Demonstration starts in the following cases:
When the menu screen is closed after [DEMO
MODE] is set to [ON].
With [DEMO MODE] set to [ON], if there is no
operation for about 3 minutes after the power
switch is set to
.
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will
resume.
NOTES:
Demo only worked with DC cord connected not
with battery.
If an SD card is in the camera, demonstration will
not take place even if it set to [ON].
[DEMO MODE] remains [ON] even if the camera
power is turned off.
OPERATION
SOUND
OFF: Turns off operation sound.
BEEP: The beep sounds when the power is
turned on or off, and at the beginning and end of
recording.
[MELODY]: Instead of a beep, a melody sounds
when any operation is performed.
Hide quick links:
Advertisement
Chapters
Table of Contents
