JVC GZ-HM200 Instructions Manual page 45

Trouble
The LCD monitor is
difficult to see.
The remaining battery
display is not correct.
Sound or video are
interrupted.
Cannot find a recorded
video/image.
The camcorder operates
slowly when switching
between video mode
and still image mode,
or when switching the
power on or off.
The lamp does not flash
during battery charging.
When connecting to
the HDMI cable, the
image or sound does
not appear on the TV
properly.
HDMI-CEC functions do
not work properly, and
the TV does not work
in conjunction with the
camcorder.
•
The LCD monitor may be difficult to see if used in bright areas
such as under direct sunlight.
•
Fully charge the battery, run it down, and then recharge it again.
•
If the camcorder is used for long periods of time in high or low
temperatures, or if the battery is repeatedly charged, the amount
of remaining battery may not be displayed correctly.
•
Sometimes playback is interrupted at the connecting section
between two scenes.
•
Select [PLAYBACK OTHER FILE] then search the video on the
index screen.
(Video files that have damaged management information can be
played back.)
•
Cancel group display and date search functions.
•
Change the setting in [VIDEO SLOT SELECTION] or [IMAGE
SLOT SELECTION]. (Files on other media are not displayed.)
•
Slide the mode switch to select the desired mode (
•
If there are many files (such as video) in the camcorder, it takes
time for the camcorder to respond. It is recommended that you
copy all files from the camcorder onto your computer, and erase
the files from the camcorder.
•
Check the remaining battery charge.
(When the battery is fully charged, the lamp does not flash.)
•
When recharging in either a hot or cold environment, ensure that
battery is being charged within the permitted temperature range.
(If the battery is being recharged outside the permitted
temperature range, recharging may stop to protect the battery.)
•
When connecting to the HDMI cable, the image or sound may
not appear on the TV properly depending on the TV connected.
In such cases, perform the following operations.
1) Disconnect the HDMI cable and connect it again.
2) Turn off and on the camcorder again.
•
TVs may operate differently depending on the specifications,
even if they are HDMI-CEC compliant. Therefore, the HDMI-
CEC functions of the camcorder cannot be guaranteed to
operate in combination with all the TVs. In such cases, set
[HDMI CONTROL] to [OFF].
Action
! #
or ).