How To Use Sony 26Pin Cable With Rm-P210U; Gy-Hd250U/Ka-Hd250U And Jvc Ccus Power Connectivity Table - JVC GY-HD250U Reference Manual



How to use Sony 26Pin cable with RM-P210U

1- Setup for Sony Cable
Remove the top-cover and change the setting of S35 & S36 dip-switch blocks
located on the 26-pin connector board.
(a) S35: All switches must be set UP.
(b) S36: All switches must be set DOWN.
2- Adjustment
Re-adjustment of the transmit Voltage (refer to SM).
(a) VOLT ADJ 15V: adjust to 15VDC +/- 0.2V
(b) VOLT ADJ 17V: adjust to 16VDC +/- 0.2V
(c) VOLT ADJ 19V: adjust to 16VDC +/- 0.2V
Note 1: If the Voltage is not correct, the viewfinder may be damaged due to over heating.
Note 2: Receive Voltage at pin-A and pin-B of the 26-pin MUST be lower than 15V. If the voltage exceeds 15VDC,
adjustment of (a) "VOLT ADJ 17V" and (b) "VOLT ADJ 19V" must be re-adjusted from 16VDC to 15VDC.


GY-HD250U/KA-HD250U and JVC CCUs Power connectivity table

20m(VC-P112) Operation
50m(VC-P113) Operation
100m(VC-P114) Operation
RM-P210U
VF-P400 VF-P550B
OK OK
OK OK
OK OK
RM-P200U
VF-P400 VF-P550B
NG NG
NG NG
NG NG
RM-P300U
VF-P400 VF-P550B
OK OK
OK OK
NG NG
Version 1.12
45