JVC GY-DV5001 Instructions Manual page 19

MEMO:
● The volume of the alarm sound is set with the ALARM
VR LEVEL item on the OTHERS (2/2) menu screen.
● When using a stereotype jack and stereo sound
should be output, the following setting should be
performed.
Set the MONITOR SELECT switch to "MIX".
Set the AUDIO MONITOR item on the AUDIO menu
screen to STEREO.
6
[DV] connector
Using a DV cable (optional), a digital video component with
DV connector can be connected here.
This connector is used for input or output of the DV signal
or to input the VTR control signal from a digital video
component with DV connector.
To record the DV signal from this connector, set the unit to
the VTR mode. (GY-DV5001 only)
(Press the MODE switch
the VTR indicator.)
● Camera mode:
The DV compressed signal (IEEE1394) of the camera
image is output.
● VTR mode:
• During playback, the tape playback DV compressed
signal is output.
• The DV input signal from this connector can be recorded
on tape. (GY-DV5001 only)
MEMO:
To receive FF/REW remote control signals from this
connector, select the setting with the REM FF/REW
MODE item on the OTHERS (1/2) menu screen.
7
Battery holder
Mount Flat shape type battery pack here.
See "Using Flat Shape Type Battery Pack" on page 34.
8
Battery holder lock release knob
This knob is used to open the battery case cover. Press the
knob while turning to open the cover.
9
[BREAKER] Breaker button
The breaker trips when the power consumption exceeds
the capacity.
If the breaker trips, confirm that there are no abnormalities
and that the power consumption does not exceed the rated
wattage. If no abnormalities are detected, press the
BREAKER button before turning the power ON again to
put the camera in the operating status.
If the unit still does not work normally, please consult the
person in charge of professional video equipment at your
nearest JVC-authorized service agent.
2. CONTROLS, INDICATORS AND CONNECTORS
^
on page 13 upward to turn on
E-19