Installation - Winegard Movin' View MV3500A Manual

Installing unit on roof of vehicle —
Install in DRY conditions only!
IMPORTANT! Do not install this system
in the rain, or under any wet conditions. Mois-
ture may affect electronics and void your
warranty!
1. For best performance and to reduce signal ac-
quisition time, park vehicle on a level surface;
level the RV.
2. Select a level spot on your roof for installation.
Using the chart,
determine the
minimum distances
to other equipment.
FIGURE 3
WARNING: Level the base front to back and side
to side. If base is not level the MV3500A may re-
quire more time to locate the correct satellite
or may not locate the correct satellite.
• Be sure no roof-mounted equipment is
blocking the satellite "line of sight", Fig. 3
• You will need to decide where the wires will enter
the vehicle. A coax and a power wire (minimum 16
gauge) will need to be run into the vehicle.
WARNING: Many +12VDC sources can cause the
unit to fail. Select a filtered source, preferably a dedi-
cated line to the battery.
!
Obstruction Ht. Unit Clearance
8" .......................................... 4"
10" ................................... 11.5"
12" ...................................... 19"
15" ...................................... 32"
UNIT BASE
3. Remove dome. Place dome in safe spot to avoid
damage. Place base on vehicle roof in the location
selected.
4. Attach each mounting foot to base by securing
with two 7/16" nylocks. See page 5 for foot locations.
5. After selecting location for unit (see number 2),
put the unit on the centerline of the vehicle.
REAR MOUNTING FOOT MUST BE PARALLEL
WITH THE CENTER LINE OF VEHICLE. See pg. 5.
6. Place the unit on the roof in its permanent loca-
tion and mark around the base bracket, Figure 4.
(Make sure the rear adjustable base foot is paral-
lel with the center line of the vehicle. Refer to
page 3, Figure 1A ).
FIGURE 4
7

Installation