Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Winegard Movin' View MV-0022
Summary of Contents for Winegard Movin' View MV-0022
- Page 1 Movin’ View Digital Satellite Mobile Antenna Model MV-0022 Made in the U.S.A. U.S. Patent Nos. 6,023,247; 6,188,300 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2002 2451997...
- Page 2 - 1-800-DIRECTV (1-800-347-3288) will deliver the best reception possible using GPS (Global Positioning System) and precision gyro- Your new Winegard RV Digital Satellite System is an scopes. easy-to-use satellite TV reception system. Because it mounts on the top of your recreational vehicle, it goes...
-
Page 3: Parts Included
Parts Included • Tools Needed • How to Unpack About this manual — We hope this manual will provide clear instructions to install and operate the MV-0022. Two symbols have been used — Indicates suggestions to make Indicates caution should be taken! processes easier for you. - Page 4 Installation - base layout GPS ANTENNA FIGURE 1 SWITCH LOCATION ADJUSTABLE EL MOTOR HEYCO ® CONNECTORS BASE FOOT POWER SUPPLY LEVELING COUNTERWEIGHT SCREW LEVELING SCREW REAR ADJUSTABLE BASE FOOT LEVELING SCREW REAR BASE FOOT MUST DIRECTLY FACE REAR OF VEHICLE AZ MOTOR ADJUSTABLE BASE FOOT...
-
Page 5: Installation
Installation Installing unit on roof of vehicle — 6. On each foot, screw the flange nut to the base of the leveling screw on the mounting foot, flange up. Install in DRY conditions only! Place rubber washer, with the rubber side up, on the nut, Figure 2. -
Page 6: Gps Installation
Installation ROOF INSTALLATION, continued GPS installation — Place the unit on the roof in its permanent location The GPS antenna is pre-wired and has a 3 foot cable and mark around the base bracket, Figure 4. (Make ® running through one of the Heyco connectors. -
Page 7: Installation & Wiring
MV unit and ground wire coming from the - (minus) on the INSTALLING THE POWER SWITCH DC Voltage Filter’s “OUT” terminal.) See diagram. WINEGARD 12 VDC POWER FILTER 4. Connect yellow spade connector to silver spade on switch. This +12 VDC Voltage Filter is included to prevent 5. -
Page 8: Connecting The Receiver
4. TEST YOUR SYSTEM BEFORE SECURING model, MV-6000 (must be used with kit MV-1202). THE GPS ANTENNA. Make sure the TV and re- Contact Winegard Company for more information.) ceiver have the correct satellite. 5. After correct satellite is found, secure GPS antenna by removing adhesive backing and securing to roof. -
Page 9: Operation
• Compatible with continental U.S. digital satel • Easy “one-button” operation lite receivers • Ability to toggle between satellites using • Winegard warranty remote control, if subscribing to multi- • MV-0022 features precision gyroscopes satellite programming To operate your system —... -
Page 10: Troubleshooting
Troubleshooting IF YOU DO NOT HAVE A SIGNAL: NOTE: The power rocker switch must be ON for the next steps. Voltage must be +12 VDC, except at the 1. The signal may be blocked by trees, hills or LNBF, see #2, Figure 9, page 11. structures. -
Page 11: Base Diagram
Base Diagram FIGURE 9 GPS ANTENNA #3 CONTROL #1 POWER SUPPLY HEYCO CON- #4 COAX CABLE AT BOX TO LNBF NECTORS CONTROL BOX (POWER WIRE, SEE DETAIL) EL MOTOR POWER SUPPLY CONTROL (DETAIL BELOW) #2 LNBF VOLTAGE AZ MOTOR CONTROL BOX DETAIL DO NOT USE EL MOTOR AZ MOTOR... -
Page 12: Specifications & Warranty
Company, 3000 Kirkwood Street, Burlington, Iowa 52601-2000, telephone 319-754-0600). Winegard Company (at its option) will either repair or replace the defective product at no charge to you. This warranty covers parts, but does not cover any costs incurred in removal, shipping or reinstallation of the product. This limited...