Sunfire SRS–210W-C Cabinet Installation Instructions Manual page 18

Baffle installation procedure
1. Remove the debris shield from the
front of the in-wall cabinet. You can
do this by cutting the cardboard
with a sharp knife and pulling out
the cardboard pieces and the plas-
tic rivets holding it in place. Do not
cut the two wires inside the cabinet,
and do not remove any sound-
proofing material.
Removing the debris shield
18
. With the help of an assistant, hold
the baffle assembly close to the
in-wall cabinet.
3. Connect the two wires from the
inside of the cabinet to the two
push-terminals on the crossover
board, following this diagram:
Red Wire
(Positive +)
Black Wire
(Negative –)
Attaching the cabinet wires to the crossover
board fixed to the woofer baffle assembly
(I-BEAM omitted for clarity)
User's Manual