Removing The Mower - Toro 74637 Operator's Manual

2
1
Figure 53
Mower decks with 2 blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here.
3
2
G009659
Figure 54
Mower decks with 3 blades
1. Blades front to rear
2. Outside cutting edges
5. Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 53 and Figure 54).
Note: If the front blade tip is not 1.6 to 7.9 mm (1/16
to 5/16 inch) lower than the rear blade tip, adjust the
front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 55).
G009658
2
1
2
3
3. Measure from the tip of the
blade to the flat surface
here
1
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut.
Note: To lower the front of the mower, loosen the
adjustment nut.
8. After adjustment, check the front-to-rear slope again.
Note: Continue adjusting the nut until the front blade
tip is 1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the
rear blade tip (Figure 53 and Figure 54).
9. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again; refer to
Side-to-Side Leveling (page 34).

Removing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin-cotter pin from the front support
rod, and remove the rod from the deck bracket (Figure
56).
36
3
2
G014634
Figure 55
3. Locknut