Hayter 131D Instruction Book page 18

5. Before you mow, check the blade rotation
control. See the instructions on "How to Ad-
just The Blade Rotation Control".
How To Remove The Mower Housing
(Figure 36)
1. Move the blade rotation control (1) to the
DISENGAGE position.
2. Move the lift lever (2) to the lowest position.
WARNING: The lift lever (2) is
spring loaded. Make sure the lift
lever (2) is locked in the lowest
position.
3. Remove the hair pins and the washers from
the adjuster arms (3). See illustrations "C"
and "D".
4. Remove the hair pins and washers from the
suspension links (4). See illustrations "A"
and "B".
5. Disconnect the extension spring (5) from
the blade control rod (6). See illustration
"E".
6. Disconnect the front hanger (9) from the
axle support. See illustration "F".
7. Remove the mower drive belt (7) from the
stack pulley (8). See illustration "G".
8. (Figure 16) Disconnect the rubber strap (1)
from the connector tube (3). Slide the con-
nector tube (3) off the extension tube (8).
9. Pull the mower housing away from the right
side of the unit.
10. To install the mower housing, reverse the
above steps.
How To Replace The Fuse
If the fuse is blown, the engine will not start.
Remove the fuse and replace with a 15 amp.
automotive fuse.
Storage (over 30 days)
At the end of each year, prepare the unit for
storage as follows.
1. Drain the fuel from the carburettor and the
fuel tank. Change the engine oil. See the en-
gine manufacturer's instructions.
2. Clean the unit.
3. Charge the battery. See "How To Charge The
Battery".
276835MA
How To Order Replacement Parts
The replacement parts are shown either on the
back pages of this Instruction Book or in a
separate Parts List Book.
Use only manufacturer's authorized or approved
replacement parts. The letter placed on the end
of the part number denotes the type of finish for
the part, C for chrome, Z for zinc, a PA for
purchased assembly. It is important that you
include this when ordering a part. Do not use
attachments or accessories not specifically
recommended for this unit. In order to obtain
proper replacement parts you must supply the
model number of your mower (see nameplate).
Replacement parts are available from your local
Hayter authorised dealer.
If you are unable to obtain parts or service in the
manner outlined above, then contact:
HAYTER LIMITED, Service Department,
Spellbrook, Bishop's Stortford, Hertfordshire
CM23 4BU.
When ordering the following information is
required:
(1) The Model Number
(2) Serial Number
(3) Part Number
(4) Quantity
18
GB