Internal Connectors - Asus M4A89GTD PRO User Manual

2.8.3

Internal connectors

1. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are
three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the
same setting.
2-30
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
Mode of device(s) Cable connector
-
Master
Slave
Master
Black or gray
Slave
Chapter 2: Hardware information
Black
Black
Gray