Biostar TForce 550 SE User Manual page 108

TForce 550 SE
MCLK drive strength
The Choices: Auto (default), 0.75x, 1.0x, 1.25x, 1.50x.
MD drive strength
The Choices: Auto (default), 0.75x, 1.0x, 1.25x, 1.50x.
DQS drive strength
The Choices: Auto (default), 0.75x, 1.0x, 1.25x, 1.50x.
Dram on-die Termination
The Choices: Auto (default), Disable, 75ohm, 150ohm, 50ohm.
Read/Write Queue bypass
The Choices: Auto (default), 2 times, 4 times, 8 times, 16 times.
Bypass Maximum
The Choices: Auto (default), No bypass, 1 time ~ 15 time.
32 Byte Granularity
The Choices: Auto (default), 64-byte, 32-byte.
DQS Training Control
The Choices: Perform DQS, Skip DQS(default).
CKE base power down mode
The Choices: Enabled, Disabled(default).
CKE based powerdown
The Choices: Per Channel (default), Per CS.
Memclock tri-stating
The Choices: Disabled (default), Enabled.
Memory Hole Remapping
The Choices: Enabled (default), Disabled.
Auto Optimize Bottom IO
The Choices: Enabled (default), Disabled.
Bottom of [31:24] IO space
The Choices: C0 (default), Min=0000, Max=00FF, Key in a HEX number..
DDRII Timing Item
The Choices: Disabled (default), Enabled.
40