Playback Using The Remote Control - JVC GR-DF550 Instructions Manual

VIDEO PLAYBACK
24
EN
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
( pg. 15)
To monitor the picture and sound from the
camcorder without inserting a tape or memory
card, set the camcorder's Power Switch to "A" or
"M", then set your TV to the appropriate input
mode.
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
Playback Using The Remote
Control
The Full-Function Remote Control Unit can
operate this camcorder from a distance as well
as the basic operations (Playback, Stop, Pause,
Fast-Forward and Rewind) of your VCR. It also
makes additional playback functions possible.
( pg. 25)
Installing The Battery
The remote control uses
one lithium battery
(CR2025).
1
Pull out the battery
holder by pushing the lock
tab.
2
Insert the battery in the
holder, and be sure to
have the "+" mark visible.
3
Slide the holder back in until you hear a click.
2
1
3 3
1
Lock tab
Beam Effective Area (indoor use)
When using the remote
control, be sure to point it
at the remote sensor.
The transmitted beam's
approximate effective
distance for indoor use is
5 m. (16 ft)
NOTE:
The transmitted beam may not be effective or may
cause incorrect operation when the remote sensor
is directly exposed to sunlight or powerful lighting.
Buttons And Functions
A
Infrared beam transmitting window
Transmits the beam signal.
The following buttons are available only when
the camcorder's Power Switch is set to "PLAY".
B
PAUSE Button
Pauses the tape (
Up Button ( pg. 26)
C
SLOW Rewind Button (
D
REW Button
Rewind/Reverse Shuttle Search on a tape
( pg. 22)
Displays previous file in a memory card
( pg. 29)
Left Button ( pg. 26)
Remote sensor
pg. 25)
pg. 25)