JVC GR-DF450 Instructions Manual page 38

MENUS FOR DETAILED ADJUSTMENT
38
EN
The "q MANUAL" settings are effective only
when the Power Switch is set to "M".
[ ] = Factory-preset
DIS
OFF: Disables the function.
[ON ]: To compensate for unstable images
caused by camera-shake, particularly at high
magnification.
NOTES:
Accurate stabilization may not be possible if hand
shake is excessive, or depending on the shooting
condition.
The " " indicator blinks or goes out if the
Stabilizer cannot be used.
Switch off this mode when recording with the
camcorder on a tripod.
5S
[OFF]: Disables 5-Second Recording.
5S: Enables 5-Second Recording. (
Anim.: Allows you to record a few frames only.
By using an inanimate object and changing its
position between shots, you can record the
subject as though it is moving.
TELE MACRO
[OFF]: Disables the function.
ON: When the distance to the subject is less
than 1 m (3.3 ft), set "TELE MACRO" to "ON".
You can shoot a subject as large as possible at a
distance of approx. 60 cm (23-5/8").
NOTE:
Depending on the zoom position, the lens may go out
of focus.
WIDE MODE
[OFF]: Records with no change in the screen
ratio. For playback on a TV with a normal screen
ratio.
CINEMA* : Inserts black bands at the top and
bottom of the screen. The
During playback on wide-screen TVs, the black
bands at the top and bottom of the screen are
cut and the screen ratio becomes 16:9. When
using this mode, refer to your wide-screen TV's
instruction manual. During playback/recording
on 4:3 TVs/LCD monitor/viewfinder, black bands
are inserted at the top and bottom of the screen
and the image appears like a letter boxed 16:9
movie.
MANUAL
pg. 42)
indicator appears.
SQUEEZE* : For playback on TVs with an
aspect ratio of 16:9. Naturally expands the
image to fit the screen without distortion. The
indicator appears. When using this mode,
refer to your wide-screen TV's instruction
manual. During playback/recording on 4:3 TVs/
LCD monitor/viewfinder, the image is elongated
vertically.
* Available only when the VIDEO/MEMORY Switch
is set to "VIDEO". (GR-DF470/450 only)
WIND CUT
[OFF]: Disengages the function.
ON : Helps cut down on noise created by
wind. The " " indicator appears. The quality of
the sound will change. This is normal.
The "s SYSTEM" functions which are set when
the Power Switch is set to "M" are also applied
when the Power Switch is set to "PLAY".
[ ] = Factory-preset
BEEP
OFF: Even though not heard while shooting,
shutter sound is recorded on the tape.
BEEP: The beep sounds when the power is
turned on or off, and at the beginning and end of
recording. It also activates the shutter sound
effect. ( pg. 27, 43)
[MELODY]: Instead of a beep, a melody sounds
when any operation is performed. It also
activates the shutter sound effect.
( pg. 27, 43)
REMOTE
OFF: Disables the remote control operations.
[ON]: Enables the remote control operations.
SYSTEM