Programming Bank 1 (Transmitters); Programming Bank 2 (Alarm Features) - Prestige APS-510E Installation Manual

PROGRAMMING BANK 1 (TRANSMITTERS):

1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (Siren Chirps).
3. Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn
or siren.
4. Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons of the system. For addi-
tional channel programming see transmitter programming guide found within the literature bag packaged
with this kit.

PROGRAMMING BANK 2 (ALARM FEATURES):

You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1.
(Siren Short then Long Chirp), or You can also go right to bank 2 by:
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (Siren Chirps).
3. Turn the ignition key off then on. (Siren Short Then long Chirp)
4. Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,, then
use the lock button of the transmitter to select the feature setting.
Example to set passive arming:
1. Turn the ignition key to the on position.
2. Press and release the valet/programming switch 3 times (Siren Chirps).
3. Turn the ignition key off then on. (Siren Short Then long Chirp)
4. Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button
of the transmitter to select two chirps "Passive Arm".
5. To exit the programming mode, turn the ignition key off. The program mode is automatically exited 6
seconds after the ignition switch transitions off.
The selectable features of this unit can be set manually as explained above, or online by using our web
link. The Accessory VE-PROG kit will include the necessary cables to connect to your computer along
with the web access information and application required to take advantage of this feature.
If Programming via PC while connected to +12 VDC, (Already Installed), you must manually enter the
programming mode as shown below:
1. Turn the ignition on.
2. Press and release valet switch 3 times.
3. Turn ignition off then on, off then on, off then on, off then on to enter web/on-line feature selection
Bank 5. Siren chirps 5 times indicating access to feature program mode.
4. Launch the application on your PC. Connect the module via the USB to DBI harness and follow
program prompts.
New ,The chirp and LED patterns have been changed to make it easier to determine what feature you
are in. As well, the feature bank will not time out until the ignition switch is off for more than 5 seconds.
The change will be noted when you get to feature # 11, the LED pattern will be 1 pause, 1, #12 will be 1
pause, 2, #13 will be 1 pause 3, #18 will be 1 pause 8, etc,,,. This will make it eaised for the technician
to determine what feature they are up to.
Feature Bank Reset: If you wish to reset a feature bank to the default settings,,, from within that bank,
press and hold the pushbutton on the receiver/antenna for 5 seconds or until a chirp / flash is heard from
the system. This action resets the feature bank. The feature banks are reset individually so resetting Bank
2 will not effect bank 3 & visa versa.
Page 14
128-9314
14 of 16