Can Not Get The Time To Show On The Front Of The Topfield - Topfield TRF-2100 User Reference Manual

Can not get the time to show on the front of the Topfield
The Topfield is designed to save power when in standby mode
as per the Australian MEPS standard. This reduces power con-
sumption to less then 1W when in STAND BY. This can be ad-
justed in the Settings > Others > Standby Mode, from Passive
to Active.
I am unable to get out of the MENU
No picture through RF loop out to my Television
To output an RF signal in standby mode the recorder must be
set to Active. This can be adjusted in the Settings > Others >
Standby Mode, from Passive to Active.
My Topfield recorder doesn't go to standby after instant recording (non timer
recording)
When an instant recording has been activated the recorder
will need to stay on until the recording finishes. To place the
recorder into Standby after the recording has finished press the
Power button on the remote during a recording and the follow-
ing message is displayed "RECORDER NOT FINISHED, DO
YOU WANT TO POWER OFF?" move green tab to YES and
leave recorder ON, do not execute the function. The television
may be turned off and the recorder will go into standby (sleep
mode) when the recording has finished.
Cannot view guide content
Perform a factory reset and service search to allow the unit to
restart the guide. Be sure to save your settings in the Installa-
tion section before applying a factory reset.
• With all Topfield product you are unable to exit from
the MENU unless channels have been tuned in to the
recorder.
• Check the antenna connection.
59