Table of Contents
Advertisement
INSTALLER/CONSUMER
SAFETY INFORMATION
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND USING
APPLIANCE.
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
—
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance
—
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch;
do not use any phone in your
building.
•
Immediately call your gas supplier
from a neighbor's phone. Follow
the gas supplier's instructions.
•
If you cannot reach your gas
supplier, call the fire department.
—
Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
WARNING: Improper installation,
adjustment, alteration, service or
maintenance can cause injury or
property damage. Read the installation,
operating and maintenance instructions
thoroughly before installing or servicing
this equipment.
WARNING:
For Outdoor Use ONLY.
Outdoor Gas Fireplace
Models:
ODGSR36A, ODGSR42A
Homeowner's Installation and
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
Operating Manual
7114
ODGSR
cover
11/03
C E RT I F I E D
20007114 4/08 Rev. 10
Advertisement
Table of Contents
Related Manuals for Majestic fireplaces ODGSR36A
Summary of Contents for Majestic fireplaces ODGSR36A
-
Page 1: Safety Information
Outdoor Gas Fireplace Models: ODGSR36A, ODGSR42A INSTALLER/CONSUMER SAFETY INFORMATION PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. -
Page 2: Table Of Contents
Similar noises are found with your furnace heat exchanger or car engine. It is not unusual for your Majestic Fireplaces gas fire- place to give off some odor the first time it is burned. -
Page 3: Installation & Operating Instructions
ODGSR Series Outdoor Gas Fireplace General Information This gas appliance should be installed by a qualified Enclosures for LP-Gas Supply Systems installer in accordance with local building codes and with current CSA-B149.1 Installation codes for Gas Burning Enclosures for LP-gas supply cylinders shall be ventilated by Appliances and Equipment. -
Page 4: Fireplace Dimensions
3���" (210mm) (95mm) 14���" 40" 3���" 3���" ����" (362mm) (1016mm) (95mm) (98mm) (165mm) Gas Line Access Fig. 1 ODGSR36A specification and framing dimensions. Fireplace Dimensions 7114 ODUVSR36A �����" (667mm) Specs Rough 11/03 Opening Depth 50" (1270mm) ���" (13mm) �����" (572mm) 22"... -
Page 5: Moisture Resistance
ODGSR Series Outdoor Gas Fireplace Moisture Resistance Mantels This outdoor fireplace will shed moderate amounts of WARNING: A 4" hood must be used if a water, but is not waterproof. Water and condensing wa- mantel is to be installed. ter vapor may enter the chase under certain conditions. The height that a combustible mantel is fitted above the The fireplace will not perform as an exterior wall. -
Page 6: Moisture Resistance
ODGSR Series Outdoor Gas Fireplace Hearths should slope away from the front of the fire- place and chase at 1/8 in to 1/4 in per foot. Metal safety strips must be on top of any combustible hearth materi- als used for moisture management. Framing and Finishing Black Check appliance to make sure it is levelled... -
Page 7: Gas Specifications
To replace the valve access panel line up the FP1642a two pins with the holes in the surround bottom and concrete install push the panel over the front of the hearth pan. (Fig. 9/06 2. Lift the brick with the Majestic logo on it. (Fig. 6) 20007114... -
Page 8: Exterior Chase Installation
ODGSR Series Outdoor Gas Fireplace Gas Line Installation *Do not install header until unit is in place. This appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during any pressure equal to or less than 1/2 psig (3.45 kPa). -
Page 9: Remote Wall Switch
ODGSR Series Outdoor Gas Fireplace Remote Wall Switch NOTE: Use an approved outdoor switch. Pilot 1. Thread wire through the low voltage wire access hole located on either side of unit. Do not cut wire or insu- lation on metal edges. Ensure that wire is protected. Run the other end to a conveniently located wall receptacle box. -
Page 10: Operating Instructions
ODGSR Series Outdoor Gas Fireplace Operating Instructions Log Installation Right Cross 1. Remove logs from the packaging. As with all plastic, these bags Left Cross are not toys and should always be kept away from children and infants. 2. Place left rear log on rear log support. Right Rear Ensure that log is firmly positioned and there is no side-to-side movement. -
Page 11: Flame Adjustment
flames. Compare them to the il- lustrations below (Figs. 16, 17, 18). If any of the flames appear abnormal call a service person. Red Glow LG319 Fig. 17 ODGSR36A flame appearance. LG319 ODUVSR36 log flames 11/24/03 djt LG320 Fig. -
Page 12: Optional Weather Enclosures
An optional weather enclosure is available to protect An optional stainless steel hood is available for both the the burner when not in use. ODGSR36A and ODGSR42A. CAUTION: Do not use the weather enclosure NOTE: The stainless steel hood may NOT if the unit has glass doors installed. -
Page 13: Lighting & Operating Instructions
ODGSR Series Outdoor Gas Fireplace Lighting and Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manu- •... -
Page 14: Troubleshooting
ODGSR Series Outdoor Gas Fireplace Troubleshooting Nova SIT 820 Standing Pilot START CHECK Supply Line Hooked up Gas Supply On Shutoff Valve Open Lockout has engaged. Wait 60 seconds and try again. Piezo not tight enough for good ground. Pilot Lights with For spark at electrode while Piezo Ignitor depressing Piezo (Red Button) -
Page 15: Maintenance
ODGSR Series Outdoor Gas Fireplace Maintenance Burner and Burner Compartment Cleaning the Standing Pilot It is important to keep the burner and the burner Control System compartment clean. At least once per year the logs The burner and control system consists of: should be removed and the burner compartment vacuumed and wiped out. - Page 16 ODGSR Series Outdoor Gas Fireplace 1. ODGSR42A Logs 1. ODGSR36A Logs 4a/b 12a/b 19a/b 7114 18a/b CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. ODGSR36A, ODGSR42A Ref.
-
Page 17: Replacement Parts
Contact CFM Corporation for questions concerning prices and policies covering replacement parts. Parts may be or- Model and serial numbers are listed on the rat- dered through your Majestic Fireplaces distributor or dealer. ing plate (located on right side of combustion chamber). -
Page 18: Accessories
ODGSR Series Outdoor Gas Fireplace Accessories The following accessories are available from your local Majestic Fireplaces distributor. Each accessory comes with a separate installation instruction for mounting to the particular firebox. Be sure to read each instruction thoroughly before installing. -
Page 19: Warranty
ODGSR Series Outdoor Gas Fireplace LIMITED LIFETIME WARRANTY PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fireplaces, and all Majestic brand gas fireplaces equipped with an Insta-Flame Ceramic Burner, or standard steel tube burner. •... - Page 20 CFM Corporation 2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www.cfmcorp.com...