Roberts Gorden AG15ST Installation, Operation & Service Manual page 50

®
B AG I
LACKHEAT NSTALLATION
Vent Pipe
Outside Air Inlet
Tubes
Gas Line
Burner Observation
Window
Blower Scroll, Wheel and
Motor
Burner Cup and Orifice
Electrode
Thermostat
Suspension Points
Sports Hall Guard,
Decorative and Protective
Grilles (optional)
Wall Tag
44
O S M
PERATION AND ERVICE ANUAL
Venting must be intact. Using a flashlight, look for obstructions, cracks on the pipe,
gaps in the sealed areas or corrosion.
The area must be free of dirt and dust.
Remove any carbon deposits or scale using a wire brush.
See Page 32, Section 9.
Inlet must be intact. Look for obstructions, cracks on the pipe, gaps in the sealed
areas or corrosion.
The area must be free of dirt and dust. Clean and reinstall as required.
Make sure there are no cracks.
Make sure tubes are connected and suspended securely.
See Page 9, Section 5
Make sure there is no sagging, bending or distortion.
Check for gas leaks. See Page 35, Section 10.
Make sure it is clean and free of cracks or holes.
Clean and replace as required.
Compressed air or a vacuum cleaner may be used to clean dust and dirt.
Clear of obstructions (even spider webs will cause problems).
Carefully remove any dust and debris from the burner.
Replace if there are cracked ceramics, excessive carbon residue, or erosion of the
electrode.
The electrode gap should be 3 mm.
There should be no exposed wire or damage to the thermostat.
See Page 37 , Section 11.
Make sure the heater is hanging securely.
Look for signs of wear on the chain or ceiling.
See Page 9, Section 5.
The grille must be securely attached. If the grille is loose or off, contact a contractor
qualified in the installation and service of gas-fired heating equipment for repair.
Check that side reflector extensions are installed correctly and secured in place if
necessary. (Decorative grille only.)
See Page 27 , Section 8.2.3 and Page 28, Section 8.3
Make sure shield is installed correctly and secured in place if necessary.
(Decorative grille only.) See Page 27 , Section 8.2.2.
If a wall tag is present, make sure it is legible and accurate. Please contact
Roberts-Gordon LLC or your ROBERTS GORDON® independent distributor if you
need a wall tag. See Page 4, Section 2.1.