Maintenance And Servicing; Inspection, Maintenance, And Cleaning - Chicago Electric 65298 Set Up And Operating Instructions Manual

maintenance and
SeRVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FRom accidental
opeRation:
make sure the trigger of the
Saw is in its "oFF" position
and unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
to pReVent SeRiouS
injuRY FRom tool
FailuRe:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
inspection, maintenance, and
cleaning
BEFORE EACH USE, inspect the
1.
general condition of the Saw. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
2. caRbon bRuSh maintenance.
The carbon brushes may require
maintenance when the motor perfor-
mance of the tool decreases or stops
working completely. To maintain the
brushes:
SKU 65298
to pReVent
SeRiouS injuRY
For technical questions, please call 1-800-444-3353.
a. Remove the brush cap on the top
and bottom of the motor housing.
b. Remove the carbon brushes from
the housing. keep track of which
orientation the old carbon brush-
es were in to prevent needless
wear if they will be reinstalled.
c. If either carbon brush is worn down
by more than 1/2, replace both car-
bon brushes.
d. To clean old carbon brushes before
reusing them, rub the contact areas
with a pencil eraser.
e. Reinsert the old carbon brushes in
the same orientation to reduce wear.
f. When installing the carbon brushes,
make sure the carbon portions of the
carbon brushes contact the motor
armature, and that the springs face
away from the motor. Also, make
sure the springs operate freely.
g. Replace the brush caps. Do not
overtighten.
note: New carbon brushes tend to spark
when first used until they wear and
conform to the motor's armature.
3. AFTER USE,
faces of the tool with clean cloth.
4. waRning! if the power cord of
this tool is damaged, it must be re-
placed only by a qualified service
technician.
clean all external sur-
Page 12