Info - Seitz roundshot Instruction Manual

3.2.9 Info

Press the „Info" button in the „Parameter" menu to activate the „Info" tab:
This menu allows to see the versions of capture software and camera firmware. By
opening the service menu field it is also possible to change advanced settings as
defined below.
Camera firmware: this function allows to update the firmware installed in the
camera. After installing a new software, connect to the camera and make sure the
battery is fully charged. Then browse the new flash file "xxx.d3flash" and click on flash
camera. Bay default the camera flash files are located in :
C:\Program Files\Seitz\Digital3\PDS\flash\flashfiles
Factory settings: by selecting "Reset" to factory settings all parameters of the
software will be restored to default values. It is possible to do so by keeping lenses,
formats and distances.
RAM test: please do not use this tool unless asked to do so by the Seitz team. This
tool checks if the RAM of the digital back works correctly.
The camera firmware is always included in the software installer. If the
capture software and camera firmware are incompatible, the installer
will automatically ask for a firmware update .
Please note that a password is required to open the service menu. The
password is : 31415 (the first 5 digits of ∏)
Instruction Manual Seitz 6x17 Digital - version 4.05 - May 2013- © by Seitz Phototechnik AG / Switzerland www.roundshot.ch
The tab contains the following options:
Software & firmware field: the currently
installed software and firmware versions are
indicated in the list:
• Camera (flash file software within the Seitz
D3 digital scan back)
• D3 Imaging Server
• Seitz Roundshot D3 (this software)
Service menu: activate the service menu
and enter the following password 31415.
This menu contains sensitive tools that
should only be used with precaution. Please
follow the indications in the software and in
this instruction manual carefully.
page 44