2.2 Step 2: Get the computer ready (continued)
If the camera cannot be detected, open the network properties and check the settings.
It is important that the network uses an IP in the same range (but not identical) as the IP
of the camera (digital scan back) and that both are located in the same subnet:
If you would still like to connect to internet while working with the camera, then set
the same standard gateway network IP as your network (for example
192.168.178.xx), the same subnet (for example 255.255.255.0) and the same DNS
server (for example 192.168.178.1). Ask your system operator for assistance.
It is also possible to change the camera IP to bring it into a desired range (for
example: 192.168.178.xx). It is important that the computer TCP/IP properties has
the same IP range than the camera (for example: 192.168.178.10). Open the external
device tab (see section 3.2.5 for more details), select the camera and change its IP
address :
Instruction Manual Seitz 6x17 Digital - version 4.05 - May 2013- © by Seitz Phototechnik AG / Switzerland www.roundshot.ch
Open network connections of your
computer.
Open LAN connection.
Choose „internet protocol TCP/IP" and
„properties".
Choose „fixed IP" and enter the following IP
address: 10.0.0.68
Subnet mask: 255.0.0.0
page 17