Circuit Protection - Frigidaire Range Use & Care Manual

installation instructions
Leveling
For good baking results, your range should be level.
Screw type leveling legs are provided at each corner
of the range at the base. Remove the storage drawer
to adjust the leveling legs. (Refer to Storage Drawer
section).
To level the range:
1. Use a 1-1/4" open end key or an adjustable wrench
to equally unscrew the four leveling legs two to three
turns each.
2. Install an oven rack in the center of the oven.
3. Move the range to its final position, then put a spirit
level on the rack to check for levelness. Take two
readings, one with the level placed diagonally first in
one direction, and then the other.
4. Use the 1-1/4" key or wrench to adjust the leveling
legs. Turn each one until the range stands firm
without wobbling.
10
Night Light Replacement (Some models)
To remove and replace the fluorescent light:
1. Lift up the control panel cover.
2. Place your fingers on the tube at approximately 20.3
cm (8") from each end.
3. To remove, turn the tube 90° then pull it out of its
sockets.
4. To replace the tube, engage the new tube into the
sockets, then rotate and snap the tube in place light
to make it sure it will lit.

circuit Protection

As a protection against surcharge, a 15 amp, 120 volt
fuse is provided for the electric outlet located on top of
the control panel.
To access the fuse(s) raise the control panel cover. Mod-
els with no electric outlet have no fuse.