Panasonic BL-C1A Getting Started page 3

3.
Set up Internet access to the camera.
Select the camera on the camera list to set up the
Internet access and click [Execute].
• This program searches for the cameras that are connected to the
router and displays their MAC Addresses, IP addresses and Port
Numbers.
MAC
Address
Port Camera
IP No. Status
Address
• The MAC Address on the rear side (see page 5 of the Operating Instructions
on the CD-ROM.) of the camera shows which camera you select on the camera
list window.
Note
If more than 20 minutes have passed since the camera was turned on, the
camera cannot be set up from the Setup Program. In this situation, restart the
camera.
Click [Automatic Setup (Internet Access)].
The Enter Network Password window is displayed. Enter the
user name and password that were set, and click [OK].
When using a router that supports UPnP
When using a router that does not support UPnP
[Disable]. Then click [Next>].
• Check if your router supports UPnP
• If you select [Disable], skip to step
Camera
List window
TM , check [Enable].
TM , check
TM
referring to the router's manual.
.
Registration with the "Viewnetcam.com
FREE DynamicDNS service"
By registering with the Viewnetcam.com FREE DynamicDNS service,
you can create a personalized web address at which your camera's live
video can always be found on the Internet. For detailed information,
access "http://www.viewnetcam.com".
To register with the "Viewnetcam.com FREE DynamicDNS
service", check [Register with Viewnetcam.com] and click
[Next > ].
If you selected [Do not register with Viewnetcam.com], skip to step
•
The Enter Network Password window is displayed.
Enter the user name and password that were set,
and click [OK].
The "Viewnetcam.com FREE DynamicDNS service"
website is displayed. Follow the displayed
instructions for registration.
• If the message "Failed to configure the router's Port Forwarding by UPnP"
is displayed, your router may not support UPnP
Enable your router's UPnP
router's manual, and try Automatic Setup again. For more information
about setting up a router, refer to the Panasonic Network Camera support
website at http://panasonic.net/pcc/ipcam/
• If the message "Failed to register with Viewnetcam.com." is displayed, con-
firm that the router is connected to the Internet.
When "Setup completed" is displayed, click [To
Single Camera page].
• When [Enable] was selected
at step .
Note
• The port number must be specified at the end of the camera URL.
For example
Using port 80: http://(Cameraname).viewnetcam.com
or http://IP Address
Using any other port: http://(Cameraname).viewnetcam.com:Port Number
or http://IP Address:Port Number
• The URL for the local network access may be different from the one set up
on the previous page.
When the Single Camera page is displayed,
setup is complete.
If a Security Warning window is displayed when installing ActiveX
•
Controls, click [Yes].
• To install ActiveX Controls on Microsoft Windows XP Service Pack
2, see "Security Warning window on Microsoft Windows XP Service
Pack 2" on the next page.
TM TM
or UPnP is not enabled.
TM
or set Port Forwarding manually following the
• When [Disable] was selected at
step .
Note
To ensure that the most current image is
displayed, Internet Explorer should be
configured as follows. This will not have a
negative effect on normal use.
1. While viewing any website, click [Tools]
[Internet Options].
2. In the section "Temporary Internet
Files", click [Settings] and check [Every
visit to the page].
.