4. Disassembly and Reassembly
4-4 Replacement of Drive Motor
Parts
Drive Motor
Drive Motor
Explaination Photo
COVER FIXING SCREW :
MATCHINE SCREW(6006-001170)
14
Explaination
1.
Take out the glass tray,
guide roller from oven cavity,
disconnect power.
2.
Remove turn table motor cover
from case bottom.
CAUTION : Remove sharp edge
after cover removal.
3.
Disconnect leads from motor.
4.
Remove the screws securing
motor to bottom of over cavity.
6.
Lift out the motor.
5.
When replacing the motor, be
sure to remount it in the correct
position.
NOTE : The shaft of motor should
6. When reassemble a drive
motor cover. give a turn in a
NOTE : Bring the spare screw
from service center.