Table of Contents
Advertisement
Chapter 4: Menu Settings
7. Press CH/OK on the transceiver or the HI/LO key on the microphone to
accept. The setting is changed. Continue in the same manner to make any
other setting changes.
To return to the previous menu level, select the [BACK] menu option or press the
CLEAR
To exit the Menu mode, press the CLEAR key again or else press the 16/PLUS key
to switch to the priority channel in standby mode.
4.2 VHF Operations
This menu group controls basic radio functions. You access VHF Operations via
the MENU key.
Scan Mode
This function automatically searches through all channels in the set for any that
are broadcasting. If a transmission is received, the scan stops on the receiving
channel as long as it is present. If the signal is lost for five seconds, the radio
resumes scanning.
You can directly access the Scan Mode menu by pressing and releasing the SCAN/
key on the microphone. When a Scan Mode is active, you can terminate the
SAVE
scan and return the radio to standby mode by pressing and releasing the key
again.
While scanning, press the microphone CH up/down keys or rotate the CH/OK
knob on the transceiver to change the scan direction. UP (key)/clockwise ( CH
knob) increases the channel while DOWN (key) /counter-clockwise ( CH knob)
decreases it.
key.
MAIN MENU
>VHF OPS
GPS SETUP
ATIS OPS
SYS CONFIG
BACKLIGHT
CONTRAST
>KEY BEEP
VHF OPS
>SCAN MODE
HI/LO POWER
SAVE CH
37
Advertisement
Table of Contents
