Status Information - NETGEAR ReadyNAS 2120 v2 Manual

Status Information

You can obtain information about the status of your ReadyNAS 2120 or 2120 v2 by reviewing
the LEDs listed in the following table.
Table 1. Status information
Indicator
Disk Activity LED (disk tray,
top)
Fault LED (disk tray,
bottom)
Error LED (front panel)
LAN 1 and LAN 2 LEDs
(front panel)
LAN port LEDs (rear panel) Two LED status indicators are built into each LAN port. One LED is green and one
Power LED (front panel)
NETGEAR ReadyNAS OS 6 Rack-Mount Storage Systems
Description
The Disk Activity LEDs have these states:
• Solid blue. A disk is present.
• Blinking. The disk is active.
• Off. No disk is present.
The Fault LEDs have these states:
• Solid red. The disk was removed, failed, or is resynchronizing.
• Off. No disk is active.
The Error LED has these states:
• Solid red. The system needs attention. Use the local admin page to
determine the problem. For more information, see the ReadyNAS OS 6
Software Manual, which is available at
http://support.netgear.com/product/ReadyNAS-OS6.
• Off. The system is healthy.
The LAN LEDs have these states:
• Solid blue. An Ethernet cable is connected.
• Blinking. The Ethernet link is active.
• Off. There is no Ethernet connection.
is amber. They indicate port speed and activity as follows:
• Green on, amber off. 1000 Mbps connection speed, no activity.
• Green blinking, amber off. 1000 Mbps connection speed, activity.
• Green off, amber on. 10 Mbps or 100 Mbps connection speed, no activity.
• Green off, amber blinking. 10 Mbps or 100 Mbps connection speed, activity.
• Green off, amber off. No connection.
The Power LED has these states:
• Solid green. The system is powered on.
• Blinking. The system is powering on or powering off.
• Off. Power is not supplied to the system.
ReadyNAS 2120 and 2120 v2
11