Ford Transit Connect electric Owner's Manual page 27

Maintenance and Specifications
When the vehicle is cold, check the level of the electronics coolant in the reservoir.
• The coolant should be at the MAX level
as listed on the reservoir.

Refer to scheduled maintenance
information for service interval
schedules.
If the coolant has not been checked at the
recommended interval, the coolant reservoir
may become low or empty. If the reservoir
is low or empty, add coolant to the
reservoir. Refer to Adding coolant in this
chapter.
Note: Automotive fluids are not interchangeable; do not use coolant/antifreeze or
windshield washer fluid outside of its specified function and vehicle location.
ADDING ELECTRONICS COOLANT
When adding coolant, make sure it is a 50/50 mixture of coolant and distilled water. Add
the mixture to the coolant reservoir, when the vehicle is cool, until the appropriate fill
level is obtained.
Use only Motorcraft
Canada) in the electronics cooling reservoir for this vehicle.
WARNING: Do not add electronics coolant when the vehicle is hot. Steam
and scalding liquids released from a hot cooling system can burn you badly.
Also, you can be burned if you spill coolant on hot components.
WARNING: Do not put electronics coolant in the windshield washer
fluid container. If sprayed on the windshield, electronics coolant
could make it difficult to see through the windshield.
®
Specialty Orange Coolant (VC-3-B in U.S., CVC-3-B in
27