Functional Overview; Features - Fujitsu Primergy CX270 S2 Operating Manual

2

Functional overview

2.1

Features

This section provides information on the features and technical data of the
PRIMERGY CX270 S2 server node. For information on key characteristics and
layout of the system board, see "PRIMERGY CX270 S2 Server Node Upgrade
and Maintenance Manual".
System board
The features of the system board are described in the "D3196-B100 BIOS
Setup Utility for PRIMERGY CX270 S2 Reference Manual" for the firmware.
Slots for expansion cards
The server node can be flexibly expanded via riser card for PCIe 3.0 x8 and via
GPGPU riser card for PCIe 3.0 x16 GPGPU.
Onboard SATA controller
A SATA controller is integrated on the system board; up to four SATA hard disk
drives can be connected to the controller. The LSI Embedded MegaRAID
software (SATA Software RAID) supports RAID levels 0, 1 and 10.
For more information on configuring the controller, see section
onboard SATA controller" on page
SAS/SATA RAID controller
The server is available with the following SAS/SATA RAID controllers for
operating the internal SAS/SATA hard disk drives:
– Modular RAID 0/1 controller with "MegaRAID functionality"
(SAS MegaRAID) for SAS1.0 and SAS2.0
RAID levels 0, 1,10 and 1E are supported for internal hard disk drive
configurations.
– Modular RAID 5/6 controller with "MegaRAID functionality"
(SAS MegaRAID) for SAS1.0 and SAS2.0
CX270 S2
48.
Operating Manual
"Configuring the
11