Table of Contents
Advertisement
WIRE HARNESS INSTALLATION
Contalned parts
Item
Part name
Part number
Q'ty
@
@
/6r
\r'
@
Monitor-tachometer
Monitor gauge wire
Trim meter wire harness
lnstrument wire harness
34200-99E00
36682-92E00
36682-90J00
36630-92E00
1
1
1
1
Procedure
(1) Remove the both side lower covers. (See page 5.)
(2) Boute the following items through the grommet e as shown
position.
. Remote control wire harness @.
. Monitor gauge wire harness @.
.Trim meter wire harness @.
.Battery cable @.
. Speed meter pickup tube @.
NOTE:
For the procedure to install optional trim sender/meter and re-
lated parts, refer to the'TRIM SENDER KIT TNSTALLATION
lN-
STRUCTIONS" that comes supplied with each unit of trim sender
kit.
(3) Connect the monitor gauge wire harness @ to the engine
side, then press fit the connector into the holder @.
(4) Connect the remote control wire harness @ and PTT wires
@ to the engine side, then press fit the connector into the
holder @. Route the monitor gauge wire harness @ and PTT
wires @ behind the connector ol @.
(5) Push the grommet O into the front panel.
NOTE:
For the remote control box/meter/wire harness connection, refer
to the WIRINQ DIAGRAM on page 16.
I
Hide quick links:
Advertisement
Table of Contents
