Connect The Wiring; Install The Ductwork; Glass Shade - Broan 761BN Instructions Manual

INSTALL THE HOUSING
(continued)
Existing Construction
4. Place housing in opening so that its bottom edge is flush
with finished ceiling. Nail to joist through keyhole on both
sides. To ensure a noise-free installation, drive another nail
through the top hole of each mounting bracket.
5. Additional mounting holes are provided for installations
where access from above is inconvenient or not possible.
Nail or screw housing directly to joists or framing.

INSTALL THE DUCTWORK

NOTE: The duct connec-
tor has a counter-balanced
damper flap. The flap will be
"open" approx. 1" when duct connector is attached to housing.
This design permits insulation to be in direct contact with fan/
light housing per UL (Underwriters Laboratories) standards.
The slightest backdraft, however, will close the damper flap,
preventing air from entering unit or finished space.
1. Snap the damper/duct connector onto housing. Make sure
that tabs on the connector lock into slots in housing. Top of
damper/duct connector should be flush with top of housing.
2. Connect 4" round duct to damper/duct connector and
extend duct to outside through a roof or wall cap. Check
damper to make sure that it opens freely. Tape all duct
connections to make them secure and air tight.
ADDITIONAL
MOUNTING
HOLES
FLUSH
MODELS 761BN • 761RB • 761WHA

CONNECT THE WIRING

SCHEMATIC WIRING DIAGRAM
L I G H T
S W I T C H
V E N T
S W I T C H
B L K
L I N E W H T
I N
G R D
S W I T C H B O X
BLACK
WHITE
BLUE
DUAL CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC
LINE IN
unit after installation is complete.
ATTACH THE GRILLE PAN AND

GLASS SHADE

1. Locate the grille pan
over the fan housing
and connect the
wiring harness plug
into white receptacle
in the fan housing.
2. Insert rod through
center hole of grille
pan. Use washer
between collar on
rod and pan.
3. Thread rod onto grille
screw in housing,
until pan is tight
against ceiling. Do not
overtighten mounting
rod.
4. Install bulbs. Use 60-
watt (maximum), B10
type, candelabra bulbs
or energy efficient
equivalent.
5. Place rim of glass shade
into opening of two
stationary hooks. Pull out
the spring-loaded hook
and latch hook over rim of glass shade.
6. Restore electrical power and check operation of the unit.
R E D B L U W H T
L I G H T
( W H I T E )
B L K B L K W H T
V E N T
( B L A C K )
W H T
G R D
U N I T
WHITE
RED
RECEPTACLE
(LIGHT)
GROUND
(bare)
WIRING
PLATE
1. Wire unit following diagram
above. Run electrical cable as
direct as possible to unit. Do not
allow cable to touch sides or top of
MOTOR
MOUNTING
PLATE
GRILLE
SCREW
ROD
COLLAR
WASHER
GLASS SHADE
60 WATT MAX.
SPRING-LOADED
HOOK
CANDELABRA
GRILLE
PAN
WASHER
ROD
GLASS
SHADE
Page 3
BLACK
RECEPTACLE
(FAN)
GRILLE
PAN
B10 BASE
BULBS
(2 REQ.)
STATIONARY
HOOKS