Programming To A Gto/Mighty Mule Gate Operator With A Remote Control; Initial Setup - Chamberlain KLIK3U User Manual

GATE OPERATORS

Programming to a GTO/Mighty Mule Gate Operator with a Remote Control

If you don't have an existing GTO remote control go to the previous page.
STOP
Before beginning, check the DIP switches on the GTO remote control. If any of the DIP switches are in the "0" position,
move them to either the "+" or "-" position and reprogram the GTO remote control to the gate operator (refer to the gate
operator instructions).
The images throughout this manual are for reference only and your product may look different.

INITIAL SETUP

2-BUTTON GTO REMOTE CONTROL
If the right button on the GTO remote control is programmed to
the gate operator, the GTO remote control will need to be
reprogrammed using the left button.
3-BUTTON GTO REMOTE CONTROL
If the middle button on the GTO remote control is programmed to
the gate operator, the GTO remote control will need to be
reprogrammed using either the left or right button.
1
Match the Universal Remote Control DIP switches to the
GTO remote control DIP switches:
GTO "+" = Universal Remote Control "ON"
GTO "-" = Universal Remote Control "OFF"
3
Press the program button on the Universal Remote Control
until the LED turns on.
Program Button
5
Press the program button on the Universal Remote Control
to save.
Program Button
(continued)
=
LED
NO DIP switches in the "0" position
2
2-BUTTON GTO REMOTE CONTROLS ONLY: Set the 9th
DIP switch on the Universal Remote Control to the "ON"
position.
3-BUTTON GTO REMOTE CONTROLS ONLY: Set the 9th
DIP switch on the Universal Remote Control to the "ON"
position if using the GTO left button or the "OFF" position
if using the GTO right button.
4
Press and release the Universal Remote Control button,
the LED will flash. When the LED stops flashing, continue
to press and release the button 20 times, ensuring the
LED stops flashing after each press. The code is accepted
when the gate operator is activated.
6
Test the Universal Remote Control by pressing the button.
If the gate operator does not activate, repeat the
programming steps.
8