Table of Contents
Advertisement
EX2500 Ethernet Switch Configuration Guide
Figure 5: 802.1Q Tagging (after 802.1Q Tag Assignment)
PVID = 2
VLAN Topologies and Design Considerations
VLAN Configuration Rules
26
VLAN Topologies and Design Considerations
As shown in Figure 5, the tagged packet remains unchanged as it leaves the switch
through port 5, which is configured as a tagged member of VLAN 2. However, the
tagged packet is stripped (untagged) as it leaves the switch through port 7, which is
configured as an untagged member of VLAN 2.
Port 1
Port 2
802.1Q Switch
Port 6
Port 7
Untagged member
CRC* (*Recalculated)
of VLAN 2
Data
SA
DA
This section discusses how you can connect users and segments to a host that
supports many logical segments or subnets by using the flexibility of the multiple
VLAN system. Be aware of the following VLAN properties on the EX2500 switch:
By default, the EX2500 software is configured so that tagging is disabled on all
ports.
By default, the EX2500 software is configured so that all data ports are
members of VLAN 1.
By default, the EX2500 software is configured so that the management port is a
member of VLAN 4095 (the management VLAN).
If you configure Spanning Tree, note that Spanning Tree Groups 2-128 are
allowed to contain only one VLAN.
VLANs operate according to specific configuration rules. When creating VLANs,
consider the following rules that determine how the configured VLAN reacts in any
network topology:
All ports involved in trunking and port mirroring must have the same VLAN
configuration. If a port is on a trunk with a mirroring port, the VLAN
configuration cannot be changed. For more information trunk groups, see
"Port Trunking Configuration Example" on page 45.
Tagged member
Port 3
of VLAN 2
CRC
Data
Port 8
16 bits
Outgoing
untagged packet
changed
Key
(tag removed)
Priority
CFI
VID
Tag
SA
DA
8100
Priority
CFI
VID = 2
3 bits
1 bit
12 bits
After
- User_priority
- Canonical format indicator
- VLAN identifier
BS45014A
Hide quick links:
Advertisement
Table of Contents
