Table of Contents
Advertisement
Turning on and off
For normal operation, turn off your Mio by sliding the power switch to the OFF position. Your Mio enters a
suspended state. To use it again, slide the power switch to the ON position. Your Mio will be back to where you
left off.
Shutdown and hardware reset
Occasionally, you may need to perform a hardware reset when your Mio stops responding; or appears to be
"frozen" or "locked-up."
You can perform a hardware reset by shutting down your Mio and then turning it back on. To shut down your
Mio, slide the power switch to the RESET position. To turn on your Mio after shutting it down, slide the power
switch to the ON position.
NOTE: Switching to the Reset position turns the battery off. It is recommended you move the switch to this position if you are
planning to store your Mio for any length of time.
How do I monitor the battery status?
Your Mio has an internal battery that when fully charged, should provide power for up to 3 hours.
You can monitor battery power status on the Power screen.
Note: The battery may not be fully charged when you use your Mio for the first time.
To access the Power screen, tap
How do I charge the battery?
The Battery Status bar displays External Power while the battery is charging; when the battery is fully charged,
the Battery Status bar will display at 100%.
To charge your Mio in a vehicle, plug the in-vehicle charger to the
end into the vehicle power socket, as shown in the" How do I install my Mio?" section.
To charge your Mio using your computer, see later section for details.
To charge your Mio using a mains power socket, plug the mains power charger cable to the
your Mio and the mains power charger pack into the mains power socket.
14
Moov M300-Series
Moov M400-Series
.
bottom of your Mio and the other
bottom of
Hide quick links:
Advertisement
Table of Contents
