Operation; Operating Instructions - Black & Decker BDEMS600 Instruction Manual

OPERATING INSTRUCTIONS

warnInG:
To reduce the risk of
serious personal injury, read and follow all
important safety warnings and instructions
prior to using this tool.
SWITCH
To turn the tool ON, hold it as shown in
figure a or a1 and push the on/off switch
(1) toward the front of the tool. To turn the
tool OFF, pull the on/off switch back toward
the cord.
a
a1

OPERATION

Grasp product as shown in figure a or
a1 and turn it on. NOTE: Do not rest
fingers on platen during use. Move it in
long sweeping strokes across the surface,
letting it do the work. Light pressure is all
that is required for sanding, polishing or
scrubbing. Excessive pressure will slow
the tool and produce inferior results. Check
your work often, product is capable of
removing material rapidly.
warnInG:
Shock hazard.
circumstances should this product be used
near water.
cauTIon:
To reduce the risk of
injury, turn off and unplug the tool before
making any adjustments or removing or
installing attachments or accessories.
DETAIL SANDING
Your tool is equipped with a teardrop base
which allows you to use it on large flat
surfaces and tight spots or corners.
The pad tips may wear unevenly, depending
on use.
FITTING SANDING SHEETS
• Hold the tool with the sanding pad (5)
facing upward.
• Place the sanding sheet onto the sanding
base, ensuring all the holes of the paper
line up with the holes in the sanding pad
as shown in figure b.
FINGER ATTACHMENT
The finger attachment is used for fine detail
sanding.
• Remove the screw.
• Remove the diamond-shaped pad tip (6)
from the base.
• Fit the finger attachment onto the sanding
base as shown in figure c.
• Fit and tighten the screw.
• Align the proper sanding sheet with the
finger attachment.
CORD CADDY
A cord caddy comes attached to the cord of
your sander. This accessory allows you to
easily store the tip that is not attached to the
sander.
• To insert the finger attachment into
the caddy, turn the attachment so the
Under no
pad side faces the caddy and slide it in
the direction of the arrow on the caddy as
shown in figure d.
• To insert the diamond-shaped tip into
the caddy, turn the attachment so the pad
side faces away from the caddy and slide
the tabs (9) of the tip into the caddy as
shown in figure d1.
5
b
c
d
d1
9