Connecting Spool Gun - Miller Millermatic 212 Auto-Set Owner's Manual

4-8. Connecting Spool Gun

A. Spoolmate 200
4
Tools Needed:
3/4, 5/8 in.
.
A complete Parts List is available at www.MillerWelds.com
2
3
5
3
1
Insert plug into receptacle, and
tighten threaded collar.
2
3
Route weld cable through opening
in front panel.
Route gas hose along side panel or
if unit has a hole in the rear panel,
gas hose can be routed through
wire compartment.
4
Connect weld cable to weld output
terminal.
5
Route shielding gas hose up to
regulator/flowmeter. Connect gas
hose to fitting on regulator/flowmeter.
.
1
Gun Trigger Plug
Weld Cable
Shielding Gas Hose
Positive Weld Output Terminal
Regulator/Flowmeter
Two welding guns, a MIG gun
and a spool gun, can be
connected to the welding
power source at the same time,
but only one welding gun may
be in use at any one time. If the
triggers of both welding guns
are pulled at the same time, the
weld output and wire feed
motor are disabled.
805 243-A / 243 737-A
OM-238 118 Page 15