Jeep Grand Cherokee Owner's Manual page 211

to seek up and the left switch to seek down. The radio
will remain tuned to the new station until you make
another selection. Holding either button will bypass
stations without stopping until you release it.
SCAN Button
Pressing the SCAN button causes the tuner to search for
the next listenable station in AM, FM or Satellite (if
equipped) frequencies, pausing for five seconds at each
listenable station before continuing to the next. To stop
the search, press the SCAN button a second time.
Voice Recognition Button uconnect phone — If
Equipped
Press this button to operate the uconnect phone feature
(if equipped). Refer to "uconnect phone" in Section 3.
If your vehicle is not equipped with or this feature is not
available on your vehicle, a "Not Equipped With
uconnect" message will display on the radio screen.
UNDERSTANDING YOUR INSTRUMENT PANEL 209
Phone Button uconnect phone — If Equipped
Press this button to operate the uconnect phone feature
(if equipped). Refer to "uconnect phone" in Section 3.
If your vehicle is not equipped with or this feature is not
available on your vehicle, a "Not Equipped With
uconnect" message will display on the radio screen.
TIME Button
Press the TIME button to alternate locations of the time
and frequency display.
Clock Setting Procedure
1. Press and hold the TIME button until the hours blink.
2. Adjust the hours by turning the right side TUNE/
SCROLL control knob.
3. After adjusting the hours, press the right side TUNE/
SCROLL control knob to set the minutes. The minutes
will begin to blink.
I n f o r m a t i o n P r o v i d e d b y :
4