Cisco ASR 9000 Series Configuring Network Settings page 18

Upgrading and Managing Satellite nV Software
In this example's output, Remote version, ROMMON, FPGA, and IOS must show the latest version.
Note
If it does not, an upgrade is required on the satellite. The version numbers displayed are the installed
version on the ASR 90000v. If a version number is displayed, instead of latest key word in the above
output, that would correspond to the ASR9000v image bundles in the satellite pie.
Monitoring the Satellite Protocol Status
•
RP/0/RSP0/CPU0:router# show nv satellite protocol discovery brief
Interface
--------------
Te0/1/0/0
Te0/1/0/1
(Or)
RP/0/RSP0/CPU0:router# show nv satellite protocol discovery interface TenGigE 0/1/0/0
Satellite ID: 100
Status: Satellite Ready
Remote ports: GigabitEthernet0/0/0-15
Host IPv4 Address: 101.102.103.104
Satellite IPv4 Address: 101.102.103.105
Vendor: cisco, ASR9000v-DC-E
Remote ID: 2
Remote MAC address: dc7b.9426.15c2
Chassis MAC address: dc7b.9426.1594
•
RP/0/RSP0/CPU0:shanghai# sh nv satellite protocol control brief
Sat-ID
------
Inventory, EnvMon, Alarm
RP/0/RSP0/CPU0:shanghai# sh nv satellite protocol control
Satellite 100
-------------
IP address: 101.102.103.105
Status: Connected
Channels:
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
HC-724
Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
TenGigE0/2/0/9
--------------
State: Satellite Ready
Port range: GigabitEthernet0/0/10-19
To check the status of the satellite discovery protocol, use the show nv satellite protocol discovery
command.
Sat-ID Status
------ ------------------------------
100 Satellite Ready
100 Satellite Ready
To check the status of the satellite control protocol status, use the show nv satellite protocol control
command.
IP Address Protocol state
------------ --------------
101.102.103.105 Connected
Control
-------
Channel status: Open
Messages sent: 24 (24 control), received: 23 (23 control).
Interface Extension Layer 1
---------------------------
Discovered links
-----------------------
Te0/1/0/0
Te0/1/0/1
Channels
-----------------------------------
Ctrl, If-Ext L1, If-Ext L2, X-link, Soft Reset,
OL-26061-03