Fireplace Installation
WARNING: ANY INSTAL-
LATION AND SERVICE WORK
CAN ONLY BE PERFORMED BY
QUALIFIED AND AUTHORIZED
PERSONNEL. ALL INSTALLA-
TIONS MUST COMPLY WITH
ALL LOCAL CODES AND BY-
LAWS, AND INSPECTED AND
APPROVED FOR OPERATION
BY LOCAL GOVERNING AU-
THORITY PRIOR TO USE.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
Locating the Firebox
The Opti-V uses an illusory reflec-
tion technique and is designed
to work best when ambient light
levels are low. If the Opti-V is
installed in brightly lit areas, the
strong reflections may diminish
the flame.
Depending on your specific ap-
plication, installation of the unit
at a height appropriate for the
viewers enjoyment is important. It
is recommended that the follow-
ing guidelines be used for locating
the unit.
6
!
NOTE: Measurements are to
the bottom of the viewing area of
the flame.
For standing applications:
Maximum - 51 in. (129.5 cm)
Minimum - 26 in. (66.0 cm)
For sitting applications:
Maximum - 36 in. (91.4 cm)
Minimum - 26 in. (66.0 cm)
Hardwire Installation
The Opti-V is supplied in an as-
sembled state and is designed to
be permanently installed. The unit
comes ready for hardwire instal-
lation.
WARNING:
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING:
On/Off switch is set to the Off po-
sition (refer to Operation section)
and that the circuit on which the
fireplace is to be installed has the
power cut off at the service panel
until installation is complete.
!
NOTE: Please read all instruc-
tions before installing.
1. For rough in framing, the
opening should follow the
Do not attempt
Ensure that the
www.dimplex.com