Assembling The Spray Guard And Trimmer Head Auto32 (Gr2126L); Assembling Other Guards And Cutting Equipment (Gr2126L); Fitting The Spray Guard And Trimmer Head (Gt2125L) - Jonsered GT2125L Operator's Manual

Assembling the spray guard and
trimmer head Auto 32 (GR2126L)
• Fit the guard (A) intended
for use with the trimmer
head. Hook the guard onto
the shaft fitting and secure
it with the bolt (L).
• Fit the drive disc (B) on the
output axle.
• Turn the blade axle until
one of the holes in the
drive disc aligns with the
hole in the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• The trimmer head must be
split to be fitted (see the
diagram). Proceed as
follows:
• Insert your finger into the
centre hole of the cover (I)
at the same time as you
hold the cover with your
other fingers. Press the two
catches (J) that extend from
the cut-out on the bottom
section (K) using the
thumb and index finger of
your other hand. Press
apart the trimmer head
using the fingers on the
cover.
• Place the cover (I) and the
support flange (F) on the
output axle.
• Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3,5-5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the
trimmer guard as possible.
The nut is tightened when
the spanner is turned
against the direction of
rotation (left-hand thread).
• Fit the trimmer head's
bottom section (K) on the
cover (I) by pressing the
two sections together with
the cut-outs on the bottom section aligned with the catches
on the cover.
• To dismantle follow the instructions in the reverse order.
ASSEMBLY
Assembling other guards and cutting
equipment (GR2126L)
• Fit the guard (A)
• Fit the disc drive (B) on
• Turn the blade axle until
K
J
I
• Insert the locking pin
K
• Screw on the trimmer
G
F
B
I
C
• Dismantling takes place
Fitting the spray guard and trimmer
head (GT2125L)
A
Guard
• Fit the guard as shown
Trimmer head
• Fit the dust cup on the
• Hold the dust cup with
• Screw the trimmer head
intended for use with
the trimmer head. Hook
the guard onto the shaft
fitting and secure it with
the bolt (L).
the output axle.
one of the disc drive's
holes aligns with the
corresponding hole in
the gear housing.
(C) into the hole to lock
the axle.
head (H) in the
direction of rotation.
in the reverse order.
in the diagram. Tighten
securely.
shaft. The nut must be
completely covered by
the dust cup.
a spanner to prevent the
shaft from rotating.
onto the shaft.
H
13
English –