Diamondback Apex R8 Owner's Manual page 10

BB
CC
JJ
AA
HH
DD
Remove the two (2) fixing screws (CC) from the
back side of the console hinge cover (BB) the four
(4) fixing screws (AA) from the console back (X).
While supporting the console (X), join the heart rate
wire connectors (Q2) and connector (Z) and wire
harness connector (S2) with connector (Y).
Align the fixing holes in the backside of the console
(X) with console mounting plate JJ. Reinstall the
four (4) screws (AA), through the plate and tighten.
Tilt the console toward the seatback and align the
mounting holes in the console hinge cover (BB)
with the mounting holes found on the backside of
the console. Reinstall the two Phillips fixing screws
(CC) and tighten.
4
X
FINAL SETUP & INSTALLATION
Move into Position. Move the unit into final position with the help
Y
of the front transport rollers. Carefully lift and support the rear end
Z
of the unit until both transport wheels touch the ground. Slowly roll
into position unit into place.
Level the Frame for Stability. After moving the unit, ensure all
four feet touch the floor. Level the base by adjusting the leveling
feet which are integrated into each of the two rear stabilizer end
KK
caps (D). Rotate the knobs counter-clockwise to raise the feet and
D
clockwise to lower them.
Adjust the Seat. The seat slides fore and aft along a fixed rail. The
proper seat adjustment positions the user so their leg would be
slightly bent when the pedal is at the furthest position from the seat.
To move the seat, loosen the seat adjustment knob (KK) a few
turns, rotating it counter-clockwise. Release any fore/aft pressure
on the seat then pull the spring-loaded knob outward, away from
the frame to retract the positioning. Slide the seat forward or
backward along the track and release the knob, making sure the
seat pin is engaged in a positioning hole by sliding the seat along
the track. An audible clunk may be heard as the pin enters the hole.
With the seat into position, rotate the knob clockwise until tight.
Visual Inspections. Inspect the unit for loose bolts, hardware,
knobs or pins and make sure the unit is level before beginning an
exercise session.
Connect to Power. Plug the AC adaptor in an power outlet. Plug
the other end into the input jack (HH).
5
9