Steps For Starting Your Furnace - Payne PG9MAA User's Information Manual

STEPS FOR STARTING YOUR FURNACE

1. Set your room thermostat to the lowest temperature setting. (See Fig. 6.)
2. Close the external manual gas valve. (See Fig. 7.)
3. Turn off electrical supply to the furnace. (See Fig. 8.)
4. Remove the main furnace door. (See Fig. 9.)
5. Gas valve will have EITHER a control switch or control knob to turn ON or OFF. Turn control switch or knob on the gas valve
to the OFF position and wait 5 minutes. (See Fig. 10 or 11.) Then smell for gas, including near the floor. If you smell gas, STOP!
Follow operating instructions on main furnace door.
6. After waiting 5 minutes, turn control switch or knob on the gas valve to the ON position. (See Fig. 12 or 13.)
7. Replace main furnace door. (See Fig. 14.)
8. Turn on electrical supply to the furnace and wait 1 minute. (See Fig. 15.)
9. Open external manual gas valve. (See Fig. 16.)
10. Set the room thermostat to a temperature slightly above room temperature. (See Fig. 17.) This will automatically signal the
furnace to start.
15
9
12
10
13
16
6
11
14
17