iHome iBN27 Instruction Manual page 8

Playing Audio via Aux Out
You can connect the unit to an external speaker via the Aux-out jack located on the back of the unit to
expand the audio playing in Bluetooth or Aux-In modes.
l .
Connect a 3.5 mm audio cable plug to the Aux- out jack on back of the unit and connect the other
end to the line-in jack on your external speaker.
2. Move the
Power ON/OFF Switch
to the ON position (right).
3. Power on a Bluetooth or aux-in audio device and use the controls on the device to play or pause audio,
navigate tracks and control volume.
4. When done listening, move the
Power ON/OFF Switch
to the OFF position (left) to turn the unit off.
Remember to turn off your audio device, too.
Playing Audio From a Computer via USB
The included micro USB to standard USB cable lets you play audio from a USB port on a Mac or PC while
charging the iBN27.
l .
Connect the micro USB plug to the micro USB charging/ audio port on the back of the unit.
2. Connect the standard USB plug end of the cable to a USB port on your computer. Below are typical
setup steps for PC
&
Mac.
Setting up on a PC:
The iBN27 should automatically load required audio drivers onto your PC when connected via USB.
Under
Control Panei>Sound,
select "iHome iBN27" and click on "Set Default" .
Setting up on a Mac ( OSX):
Open
System Preferences>Hardware>Sound, click on the Output tab,
then select "iHome iBN27".
3. Use the audio controls on your computer to play or pause audio, navigate tracks and control volume.
Note :
while connected via USB with iBN27 selected as the audio output source, audio will play
through the IBN27 whether it is turned ON or OFF.
4. When finished listening, stop play in your computer and disconnect the USB cable from the iBN27 OR
unselect iBN27 as an audio output source in your computer.
8