Power-Up Initialization; Operation - Detecto SlimPRO Operation Manual

Power-Up Initialization

1. Turn the scale over and locate the removable panel on the bottom of the scale.
2. Remove the panel to gain access to the battery holder.
3. Install the included four (4) "AAA" size alkaline batteries.
4. Place the scale on a flat level surface, such as a desk, table or bench.
5. Lightly press on the scale to turn it on.
6. The scale display will show
7. The scale has completed initialization and is ready for normal operation.

Operation

1. Step on the scale.
2. The scale shows "0.0" during wake up and then shows the users weight.
3. The weight is locked once a stable weight is obtained.
4. If the user steps off the scale before a stable weight is obtained, the scale will display
0.0lb/kg for 5 seconds, show a moving zero (see Fig. 2: below) and then the scale will
automatically turn OFF.
5. When the user steps off the scale after a stable weight is obtained, the users weight will
be displayed for 5 seconds, then a moving zero will be shown (see Fig. 2: below) and then
the scale will automatically turn OFF.
6. If the user is still on the scale over 20 seconds, the scale will automatically turn OFF
without showing the moving zero.
2
, change to a moving
oooo
Fig. 1: Measured Weight Screens
Fig. 2: Moving Zero
8525-M336-O1 Rev A  SlimPRO Operation
and then turn off.
o