Programme Correction; Cancel A Programme Or Switch The Appliance Off; How To Interrupt A Programme; How To Open The Door During The Cycle Of A Programme - John Lewis JLWM 1410 Instruction Manual

flashes 3 times and the message Err is
displayed for a few seconds.
Important!
You must set the washing machine to Pause
before you make any change in the
programme in progress.

Programme correction

As long as the wash programme has not
been started yet, the programme selection
can still be changed.
If the programme has been started, it is only
possible to correct the functions, if the
programme is first interrupted by pressing
button 10. In this case only some of
functions can be selected depending on the
programme which is running.
If the wash programme is to be corrected by
means of buttons 3, the appliance must first
be switched off by pressing the button 2.
Switch on the appliance, set the new
programme and press button 10 again. The
water remains in the tub.
Cancel a programme or
switch the appliance off
If a washing programme that has already
started is to be cancelled, press button 2 to
RESET the programme. All lights and the
display go out and the appliance is switched
off. The previously selected programme is
now cancelled. Another programme can
now be selected.
Important! If any problems occur as the
programme runs, always first switch the
appliance off by pressing button 2 before a
new programme is selected. Consider the
temperature to which the washing water
may already have been heated. Press the
button 10 to interrupt a programme which
is running, the corresponding green pilot
light starts blinking.
How to interrupt a
programme
Press the button 10 to interrupt a
programme which is running, the
corresponding green pilot light starts
blinking.
Press the same button again to restart the
programme.
How to open the door
during the cycle of a
programme
You can open the door, after having set the
washing machine to Pause, provided the
following conditions exist:
• The washing machine is not in the heating
phase
• The level of the water is not high;
If these requirements are met, when you
pause the washing machine, the «Door
lock» light goes off and the door can be
opened.
Should it not be possible to open the door,
and should it be absolutely necessary to do
so, switch the appliance off by pressing
button 2. After a few minutes, you can open
the door.
Pay attention to the level and
temperature of the water in the
washing machine!
16