Starting The Pbx; System Initialization Procedure - Panasonic KX-TDA50 Installation Manual

2.10.1 Starting the PBX

2.10 Starting the PBX
2.10.1 Starting the PBX
Before Starting the PBX
Before starting the PBX, please pay attention to the following:
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the main board before startup.
Starting the PBX
CAUTION
•
Before touching the System Initialize Switch, discharge static electricity by touching ground or wearing
a grounding strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data is cleared. To restart the PBX, refer to
"4.1.4 Using the Reset Button".
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".

System Initialization Procedure

1.
Slide the System Initialize Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
ALARM Indicator
110 Installation Manual
Reset Button
System Initialize Switch
Document Version 2010-11