Replacing An Existing Module Using The Programming Tool - Honeywell AlarmNet 7845GSM Installation And Setup Manual

Possible Errors
Registration BAD
Timed Out
Registration BAD
Pri Sub ID BAD
Registration BAD
2nd Sub ID BAD
Registration BAD
Pri&Sec – IDs BAD
Registration BAD
Pri ID – Need PIN
Registration BAD
2nd ID – Need PIN
Registration BAD
Pri&2nd – Need PIN

Replacing an existing module using the programming tool

Enter PIN#
Registering ...
Registration
SUCCESS
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM
Displayed if no response to the registration request is
received.
Indicates the city, central station, or customer number
for the labeled account(s) is not accepted. The ID
information was either entered in error, or the central
station failed to pre-authorize programmed ID numbers
with AlarmNet customer service.
Indicates the city, central station, or customer number
for the Secondary account is not accepted. The ID
information was either entered in error, or the central
station failed to pre-authorize programmed ID numbers
with AlarmNet customer service.
Displayed when both primary and secondary subscriber
IDs are invalid.
Displayed if this is a repair/replacement, or an error was
made in programming the Primary account information
of 7845GSM for an existing account. This prompt
appears for 2 seconds. See the Replacing an existing
module section below for further displays.
This prompt is displayed if this is a repair/replacement,
or an error was made in programming the Secondary
account information of 7845GSM for an existing account.
This prompt appears for 2 seconds. See the Replacing
an existing module section below for further displays.
This prompt is displayed if this is a repair/replacement,
or an error was made in programming BOTH the
Primary and Secondary account information of
7845GSM for an existing account. This prompt appears
for 2 seconds. See the Replacing an existing module
section below for further displays.
This prompt appears after pressing the down arrow [↓ ↓ ↓ ↓ ]
on the 7720P. Enter a 4-digit alphanumeric PIN number
provided by your central station, your dealer or an
authorized AlarmNet representative.
NOTE: If you are replacing an existing "C Series" radio,
you can enter the last four-digits of the "C Series" MIN
number.
Press the [ENTER] key.
The registration message is sent and the unit waits for
acknowledgement.
If the PIN is valid, the new 7845GSM is registered and
the old unit unregistered. Additionally, AlarmNet sends
a substitution alarm to the central station.
Section 4: Registration
4-3