Front Bezel Configuration Example - SonicWALL NSA E7500 Getting Started Manual

Front Bezel Configuration Example

LAN IP Configuration
The SonicWALL NSA E7500 is assigned the default LAN IP of
192.168.168.168. Complete the following steps to change it to
192.168.168.10.
1. Press Right to exit screen-saver mode if not at the root
menu.
2. Press Down to select the Configuration entry.
3. Press Right to enter Configuration Mode.
4. Input PIN (76642 by default; SONIC on a phone keypad.)
a. Press Up or Down until the cursor displays 7,
press Right.
b. Press Up or Down until the cursor displays 6,
press Right.
c. Press Up or Down until the cursor displays 6,
press Right.
d. Press Up or Down until the cursor displays 4,
press Right.
e. Press Up or Down until the cursor displays 2,
press Right.
Page 12 Front Bezel Configuration Example
f. Press Right.
5. Press Down until X1 IP is selected (four times).
6. Press Right to configure X1 IP.
7. Edit X1 IP:
a. Press Right ten times to select the tenth digit.
b. Press UP or Down until the cursor displays 0.
c. Press Right once to select the next digit.
d. Press UP or Down until the cursor displays 1.
e. Press Right once to select the next digit.
f. Press Up or Down until the cursor displays 0.
g. Press Right to finish editing the X1 IP.
h. Press Right again to confirm changes.