Operating Instructions; Pre-Lighting Checklist; Lighting Instructions - Lennox Hearth Products RDV33/40 IPI Install And Operation Instructions

OPERATION

Pre-Lighting Checklist

Be sure to check these items before the initial lighting of the insert:
c Gas pressure has been checked carefully - see Page 16.
c All gas fittings have been checked for leaks.
c All clearances to combustibles have been met-see Page 10.
c All combustible materials have been removed from the area
in front of the insert.
c All vented areas of the insert face are unobstructed.
c House is ventilated to clear initial paint curing odors - see
Page 23.
c All packaging materials have been removed from the firebox.
c While appliance is cool, fingerprints or other marks have been
cleaned from any plated surfaces with denatured alcohol and a
soft cloth. Marks left on these surfaces may become permanent
into the finish if not removed prior to burning the unit.
c Firebox liner panels and log set have been installed.
c The glass door is in place and is properly sealed.

Operating Instructions

FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly,
a fire or explosion may result causing property damage,
personal injury or loss of life.
A. This appliance is equipped with an ignition device which automatically
lights the pilot. Do not try to light the pilot by hand.
B. BEFORE OPERATING smell all around the appliance area for gas. Be sure
to smell next to the floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. If any portion of this appliance does not operate as the instructions
indicate, do not try to repair it, call a qualified service technician. Do not
use tools. Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately
call a qualified service technician to inspect the appliance and to replace
any part of the control system and any gas control which has been under
water.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above on this label.
2. Read the operation section of the Installation and Operation manual.
3. Turn the burner ON/OFF switch in the control compartment to "OFF."
4. Turn "OFF" all electric power to the appliance.
5. This appliance is equipped with an ignition device which automatically
lights the pilot. Do not try to light the pilot by hand.
6. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP!
Follow "B" in the safety information above on this page. If you do not
smell gas, go to the next step.
7. Turn on all electric power to the appliance.
8. Turn the burner ON/OFF switch in the control compartment to ON. After
approximately 4 seconds the spark ignition system will spark for 60
seconds to light the main burner.
9. If the appliance will not operate, follow the instructions "To Turn Off Gas
To Appliance" and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Turn the burner ON/OFF switch in the control compartment to "OFF."
2. Turn off all electric power to the appliance if service is to be performed.
3. Close the main line gas shut-off valve.
19