Synth Parameters - Korg ToneWorks Pandora PX4D Owner's Manual

Synth parameters

Oscillator selection:
0...15 (GAIN/MID knob) 2: Sine wave 1 octave down
VCF setting: 0...10.0
(BASS knob)
Direct level: 0...10.0
(TREBLE knob)
Synth level: 0...10.0
(VOLUME knob)
Threshold adjustment: Adjusts the sensitivity of the synth in response to the volume of the
1.0...10.0 (Value dial)
The Synth is effective only when single notes are played. The desired effect will not be obtained if
chords are played.
If your instrument is not tuned correctly, the results may not be as you expect. In this case, re-tune
your instrument.
36
0: Sawtooth wave 2 octaves down 1: Sawtooth wave 1 octave down
4: Sine wave
6: Sine wave 1 octave up
Oscillators 8...15 are oscillators
Voltage Controlled Filter sensitivity adjustment.
0...4.7 is sensitivity adjustment in the positive (+) direction, and 5.0...10.0
is sensitivity adjustment in the negative (-) direction.
Set this to 5.0 for a sine wave oscillator.
Adjusts the volume of the guitar or bass.
Adjusts the volume of the synth.
guitar or bass. Adjust this as appropriate for your guitar, bass, or pickup.
3: Sawtooth wave
5: Sawtooth wave 1 octave up
7: Sine wave 2 octaves up
0...7 with portamento turned on.